Need Pistons for 103" Build..

[TIREATER]

My St Bob blew the motor.... So I'm going to do a SE stroker crankshaft...
I have pro st heads decked .040 with a .040 com. head gasket...
95", And 37 chain drive cams, Weisco 9-1 flat tops, CR 9.7-1..
What pistons do I need to keep the same CR..Thanks...Andre'

[Mike]

You'll need to either open up the heads chambers to add cc's or have a set of piston reveresed domed (similar to 883/1200 conversion pistons). The trick to the later will be getting a set of piston with enough dome material to accomadate the machining leaving enough dome thickness to prevent burn through when done. I would ask Axtell Sales for a possible piston. Another alternative is to stay with your combo but add a little more cam timing to work with the higher compression, this would give both higher tq and hp numbers with the right cam (this would be my choice).
Mike

[TIREATER]

Thanks for that...My St Bob is a little light for the And 37...Maybe a Wild Things TC4, SE204 or TW-44...
What would you recommend...Thanks ..........Andre'

[Mike]

Look at the Woods TW8 or T-man 590 with 10.2-10.5 compression. Valve to valve and spring clearances should be checked.
Mike