crane ignition

[harleyjo56]

Mike, I have a 2001 flsts 45mm mikuni carb, eldebrock heads, crane ignition hi4tc,je 10.25 pistons, crane cam .619 lift, and currently running a v&hines pro pipe. I just bought a d&d fatcat and would like to ask, what you think my ignition should be set at? or give me a base line to start, I was running about 95hp and 98torque with the pro pipe! Thanks Joe

[Mike]

Apologies for late reply. We start with the base settings recommended by Crane, then dyno tune from there. We like the multispark/single fire mode, rear cyl offset of +2, and slope 5 as most common final settings. Slope may change depending on compression and motor size.
Mike