TPS and Injector wiring 2002 -> se throttle body

[HDMT]

Mike,

Does it matter how to connect the wires on the TPS and the injectors?
(To fit a SE 50mm on a 2002 Ultra)

[Mike]

You'll have to purchase the wire end plugs and pin terminals for the TPS and injectors, then cut off the old from your bikes harness. Wire color to terminal location are critical.
We may put together an adaptor kit, but this is a ways off.

[HDMT]

Mike,

That's a quick reply!
I'm from Europe and nobody here nows how to mount the SE 50mm to and older bike.
I do have the connectors.
Would you be so kind to give the colour codes (2002 wire harness) + connector point (SE 50mm)??

Thanks in advance!

[Mike]

You can use an 06L Electrical manual and simply cause your bike to match.
Pin location/wire color as follows,

Front Injector; A/Yelllow-green, B/White/yellow
Rear Injectcor; A/Yellow-green, B/Green/grey
TPS; 1/Red-white, 2/Black-white, 3/Grey-violet
IAC explained in ealier post
IAT and MAP same as earlier models and plug straight in (no changes).
Mike

[HDMT]

Thanks again